Dynon Avionics SkyView System Installation Guide - Manual (Page 119)

SV-EMS-220/221 Installation and Configuration
SkyView System Installation Guide – Revision S 7-7
Sensor and Transducer
Compatibility Level
Example sensors and transducers
A
Contacts
Fuel Level (resistive)
0-150 PSI Fluid Pressure (100411-002)
1/8”-27 NPT Fluid Temperature (100409-000)
5/8”-18 NPT Fluid Temp (100409-001)
0-30 PSI Fluid Pressure (100411-000)
0-80 PSI Fluid Pressure (100411-001)
Jabiru Oil Temperature
Jabiru Oil Pressure
Dynon 2-Wire OAT Probe (100433-003)
Dynon 2-wire Carburetor Temperature (100468-000)
Rotax CHT or Oil Temperature (801-10-1)
Flap/Trim Position
B
Everything in A, plus can be connected to a 4 to 20 mA current source
sender (e.g., Rotax P/N 956413 Honeywell and Rotax P/N 456180 oil
pressure sensors)
C
Everything in A, plus Dynon’s Capacitance-to-Voltage Converter and
other senders with active voltage output hardware. Type C inputs can
measure 0-5V DC, but can accept up to 15V DC without damaging the
input (any voltage above 5V is seen as 5V, however).
Table 14 – Sensor and Transducer Compatibility Level Key
Future firmware updates may expand the scope of the compatibility levels listed in Table 14.
The tables on the following pages specify the sensor and transducer types that are supported
by each pin on the male D37 and female D25 SV-EMS-220/221 connectors and the wire harness
wire colors. Note that the only purpose of the 25-pin SV-EMS-220/221 wire harness is for
thermocouple connections. This guide generally refers to the different variations of this as the
thermocouple harness. Each connector’s table is followed by a pin insertion view (rear)
diagram.