Dynon Avionics SkyView System Installation Guide - Manual (Page 8)

viii SkyView System Installation Guide - Revision S
Revision Revision Date Description
panels/intercom for proper audio operation.
Clarified % power only available on Lycoming / Continental engines.
Added crush washer spec for 100409-001 oil temp sensor.
Updated pitot/static test instructions.
Added metric units to most dimensions and weights.
Explained presence of unused 1.21K resistor in transponder connector kit.
Clarified fuel flow sensor placement recommendations.
Changed max SkyView displays supported to three.
Added instructions for using already-installed Dynon D10/D100 Series OAT Probes with
SkyView.
Added Rotax 912 iS information.
Added SkyView Network redundancy information to SkyView Network and Troubleshooting
sections.
Expanded ADAHRS Source Selection section with new cross-checking features.
M December 2012
Updated SV-XPNDR-261/262 Installation, Configuration, and Testing chapter, as well as relevant
appendix data, to reflect updated ADS-B Out capability, improved squat-switchless air/ground
detection and automatic mode switching.
Added basic explanation of EMS voltmeter inputs.
Clarified the boom mount does not incorporate drainage features.
Added link to FAA AIM for further ADS-B and TIS system information.
Clarified SV-XPNDR-261/262 serial port wiring.
Added engine alert inhibit information.
Added voltage measurement capability and ultimate limit for type “C” EMS inputs.
Improved standby network error troubleshooting explanation.
Updated recommendation to have servos powered whenever SkyView is powered on.
Added description of take-off position marking for trim calibrations.
Added SV-ADSB-470 installation information.
Documented move of INHIBIT ENGINE ALERTS AT BOOT option to Engine Information menu.
Updated return to service appendix.
N January 2013
Updated Serial Data Output Format Specifications. SYSTEM and EMS formats have changed for
5.1.
Documented new internal data logging feature. See appendix F.
Added a note to reinforce that the servo shear screw should NEVER be removed or adjusted in
the normal process of installing an autopilot servo.
O June 2013
Revised for SkyView v6.0.
Revised for installation of SV-COM-C25.
Revised for Expert IFR AP mode and Simplified VFR AP mode.
Updated SV-BAT-320 Initial Battery Test and Annual Test.
On multi-display systems, serial port configuration is now identical on all displays (SYSTEM
SETUP). Previously serial ports were configured individually on each display. Updated all
reference referencing serial ports that the same serial ports MUST be used on all displays.
Updated SV-ADSB-470 section to reflect that a Garmin GTX 330ES will now enable display of