Dynon Avionics SkyView System Installation Guide - Manual (Page 22)

Introduction
1-4 SkyView System Installation Guide - Revision S
b. Ensure that a valid HEX CODE is set: SETUP > TRANSPONDER SETUP > AIRCRAFT HEX
CODE. A caution message – XPNDR HEX CODE NOT SET will appear if a transponder
is configured in SkyView, but the HEX CODE is not set to a valid number.
c. Traffic will not be displayed unless you are in an area covered by an TIS radar site
(US only)
15. Common issues for setting up Dynon Autopilot
a. Servos must be powered ON
b. Servos must be recognized on SkyView Network (above)
c. AIRSPEED LIMITATIONS must be set (at least one must be actively adjusted from the
defaults) before the Autopilot can be configured: SETUP > PFD SETUP > AIRSPEED.
d. SERVO CALIBRATION must be performed: SETUP > HARDWARE CALIBRATION >
SERVO CALIBRATION > CALIBRATION.
e. After SERVO CALIBRATION is successfully completed, AP status will now be displayed
on the SkyView display top bar.