Dynon Avionics SkyView System Installation Guide - Manual (Page 76)

SV-D700 / SV-D1000 / SV-D1000T Installation and Configuration
4-14 SkyView System Installation Guide - Revision S
Only one device can provide traffic information to SkyView at any moment. If you
have more than one device connected to SkyView that is capable of providing
traffic (such as, but not limited to, SV-XPNDR-261/262 (TIS), SV-ADSB-470, Zaon
XRX, etc.), the devices provide traffic information with the following priority,
based on the completeness of the traffic portrait they provide:
1. SV-ADSB-470 with full traffic (ADS-B ground station reporting with radar
coverage)
2. TIS transponder from SV-XPNDR-261/262 or Garmin GTX 330 / ES (when in an
active TIS coverage area)
3. FLARM
4. Zaon
5. SV-ADSB-470 with No RADAR (ADS-B reception, but without ground ADS-B
station coverage or radar target inclusion).
Dynon SV-XPNDR-261/262 Transponder
See the SV-XPNDR-261/262 Installation, Configuration, and Testing section for detailed
instructions on how to set up the serial connection to the SV-XPNDR-261/262.
Note that if you are using a Dynon SV-XPNDR-261/262 Transponder, none of the encoder
options in the below sections should to be set for the Dynon SV-XPNDR-261/262 module to
receive pressure altitude. Instead, when the Transponder is set up as described in the SV-
XPNDR-261/262 Installation, Configuration, and Testing section, it is automatically configured
to receive pressure altitude from SkyView. Alternatively, systems that require the use of an
external altitude encoder can be configured per the following section to have SkyView pass
along an external pressure altitude source.
Dynon SV-ADSB-470
See Section 14 - SV-ADSB-470 Installation, Configuration, and Testing for detailed instructions
on how to set up the serial connection to the SV-ADSB-470.
Garmin GTX 330ES
To enable ADS-B traffic with a Garmin GTX 330ES, both the serial port transmit and serial port
receive between SkyView and the GTX 330ES must be connected and configured. The GTX
330ES must be fully configured to output ADS-B Out, which requires a TSO’d GPS position.
Contact Garmin for correctly configuring the GTX 330ES ADS-B Out capability. Also see SV-
ADSB-470 Installation, Configuration, and Testing for additional configuration.

SETUP MENU > SYSTEM SETUP > SERIAL PORT SETUP > SERIAL PORT x SETUP > SERIAL IN
DEVICE > GARMIN GTX 330ES

SETUP MENU > SYSTEM SETUP > SERIAL PORT SETUP > SERIAL PORT x SETUP > SERIAL OUT
DEVICE > ICARUS ALTITUDE 100ft OR ICARUS ALTITUDE 10ft