Dynon Avionics SkyView System Installation Guide - Manual (Page 342)

Appendix A: Maintenance and Troubleshooting
20-4 SkyView System Installation Guide - Revision S
8. On the recently repaired display, confirm that the tail number under SYSTEM SETUP >
AICRAFT INFORMATION is now set to the actual aircraft tail number, not DYNON. This
implies that all settings and configurations have been synchronized from the other
display.
SV-ADAHRS-200/201 Modules
1. Reinstall the ADAHRS in the aircraft.
2. Reconnect all harnesses and connections as originally installed.
3. Power up the entire SkyView System (all displays, modules, servos, etc.).
4. From any display in the aircraft, reconfigure SkyView Network under SETUP MENU >
SYSTEM SETUP > NETWORK SETUP > CONFIGURE…
5. Confirm all SkyView Network components are found, including the reinstalled ADAHRS.
6. If the ADAHRS is the same serial number as the one you returned for repair, no further
actions should be required. However, Dynon recommends double checking the
performance of compass and AOA calibration. If these do not seem to work as well as
they previously did, redo those calibrations.
7. If the ADAHRS is not the same serial number as the one you returned for repair, all
setup and calibration steps in the SV-ADAHRS-200/201 Installation and Configuration
section of the SkyView Installation manual should be performed because this ADAHRS is
being installed for the first time.
Autopilot Servos
1. Reinstall the servo in the aircraft.
2. Reconnect all harnesses and connections as originally installed.
3. Power up the entire SkyView System (all displays, modules, servos, etc.).
4. From any display in the aircraft, reconfigure SkyView Network under SETUP MENU >
SYSTEM SETUP > NETWORK SETUP > CONFIGURE…
5. Confirm all SkyView Network components are found, including the reinstalled servo.
6. Assuming the Autopilot was previously set up and working correctly, you only need to
recalibrate the servos by going to SETUP MENU > HARDWARE CALIBRATION > SERVO
CALIBRATION > CALIBRATION and following the on-screen instructions.
All other SkyView Network Components
1. Reinstall the SkyView Network component in the aircraft.
2. Reconnect all harnesses and connections as originally installed.
3. Power up the entire SkyView System (all displays, modules, servos, etc.).
4. From any display in the aircraft, reconfigure SkyView Network under SETUP MENU >
SYSTEM SETUP > NETWORK SETUP > CONFIGURE…
5. No further action should be required.
Operational Status
SkyView displays give users access to vital operational information in the Display Hardware
Information Page (SETUP MENU > LOCAL DISPLAY SETUP > DISPLAY HARDWARE