Dynon Avionics SkyView System Installation Guide User Manual
Page 123
SV-EMS-220/221 Installation and Configuration
SkyView System Installation Guide – Revision S
7-11
configure SkyView to support any installations that are not already supported in
the preconfigured downloadable resources.
Figure 30 is a pin insertion view (rear) of the male D25 on the Thermocouple Wire Harness.
Figure 30 – Thermocouple Wire Harness Male D25 Pin Insertion View (Rear)
Sensors Powered by the SV-EMS-220/221
Some sensors use a 5V (pin 18; white/red wire) or 12V (pin 15; red wire) power supply provided
by the SV-EMS-220/221 module. These outputs are designed to handle a limited amount of
current. The typical Lycoming/Continental/Rotax/Jabiru installations as described in the rest of
this chapter are designed to not exceed these current limitations. However, more complex and