Dynon Avionics SkyView System Installation Guide - Manual (Page 57)

Basic SkyView Display Operation
SkyView System Installation Guide – Revision S 3-13

SHOW WIDE ANGLE VIEW BUTTON – Enables / disables the appearance of the WIDE button
PFD > MODE menu.
If you enable or disable WIDE view, then set SHOW WIDE ANGLE VIEW BUTTON to NO, the
previous wide setting (enabled or disabled) will persist. Example:
1. SHOW WIDE ANGLE VIEW BUTTON > YES
2. PFD > MODE > WIDE (gray background, indicating wide angle view is enabled)
3. SHOW WIDE ANGLE VIEW BUTTON > NO
Will result in:

The WIDE button will not appear in the PFD > MODE menu

Wide angle view will always be displayed in the PFD.

BARO MISMATCH WARNING – Enables / disables a warning message when the current
SkyView BARO setting and nearest valid ADS-B METARS report barometric pressure are
significantly different.
EMS Setup Menu
This menu contains links to the following wizards and menu:

Engine Information – Enter this wizard to record important information regarding the
engine in your aircraft such as engine type and horsepower. The user-entered information
here is used to calculate quantities such as % power and special operating limitations.

Sensor Input Mapping... – Enter this wizard to map engine and environmental sensors to SV-
EMS-220/221 pins. Reference the EMS Sensor Input Mapping Section of this guide for
instructions on how to navigate and use this menu to map sensors.

Screen Layout Editor – Enter this wizard to configure the placement and style of the
onscreen EMS gauges on EMS pages. Reference the EMS Screen Layout Editor Section of
this guide for instructions on how to use this wizard.

Sensor Setup–Enter this menu to configure the graphical display properties of mapped
sensors. Reference the EMS Sensor Setting Section of this guide for more information
regarding sensor setup.
MAP Setup Menu
This menu contains links to the following wizards and menus:

Terrain Warning Colors – Sets whether red and yellow terrain warning are provided on the
Map Page

Red and Yellow Start – When the above setting is set to “YES”, these settings how far above
or below the aircraft’s current altitude the red and yellow colors persist.
Autopilot Setup Menu
This menu is not accessible until the autopilot servos in the system have been
successfully calibrated and tested. Reference the Autopilot Servo Calibration and
Test Procedures Section of this guide for more information.
This menu contains links to the following menus: