Dynon Avionics SkyView System Installation Guide - Manual (Page 50)

Basic SkyView Display Operation
3-6 SkyView System Installation Guide - Revision S
Return to previous menu
Move either joystick toward the left
(saves settings)
OR
Press BACK (saves settings)
OR
Press CANCEL (does not save
settings)
Save adjusted value Press ACCEPT
Reset adjustable value Press DEFAULT
Save settings and return
to Main Menu
Press EXIT
Table 8 – Menu Navigation Summary
Basic Display Operation Procedures
This subsection covers basic operation procedures for displays. Detailed instructions for various
menus and individual menu items are described later in this guide.
How to Turn the System On or Off
Table 9 summarizes the procedures for toggling SkyView system power states.
SkyView System
Displays
Toggle SkyView System Power
One display
Toggle primary power state
OR
Toggle display power by pressing and holding button 1
Multiple displays
Toggle primary power state
OR
Toggle all displays off or on by pressing and holding
button 1 on each display.
Table 9 – How to Toggle SkyView System Power State
Loss of External Power with Backup Battery Connected
If external power is lost to a display that is connected to a backup battery, it will either stay on
for an additional 30 seconds or stay on indefinitely depending on whether or not the aircraft is
in flight. This feature minimizes backup battery discharge when on the ground and
master/external power is shut off normally while simultaneously reducing pilot workload during
an actual in-flight power loss.
If the aircraft is not in flight, SkyView displays the message “POWERING DOWN IN xx SECONDS”
while counting down from 30 seconds. During this countdown, the menu displays the buttons
STAY ON and PWR OFF at the bottom of the screen. Press PWR OFF to turn off the SkyView
display immediately. Press STAY ON to keep the SkyView display on via the connected backup
battery. If STAY ON is pressed, the display will continue to use the backup battery to power