Dynon Avionics SkyView System Installation Guide - Manual (Page 39)

System Planning
SkyView System Installation Guide – Revision S 2-17
Dynon Part Number Description
SV-NET-SERVO
SkyView Network Cabling Kit for Autopilot Servos
(includes 20 feet of wires, connectors, connector shells, crimp contacts,
insertion tool, heat shrink, and zip ties). One SV-NET-SERVO is used for
each servo in most installations.
SV-NET-TEST
SkyView Network Test Cable–Not Aircraft-Grade. One SV-NET-TEST is
shipped with each SkyView display. (10 foot)
SV-NET-HUB SkyView Network Hub (5 SkyView Network connections)
Table 6 – SkyView System Connection Hardware
Example SkyView Systems
SkyView systems are easily scalable and can accommodate a wide variety of components
ranging from a single display with one module to multiple displays with multiple modules. The
following diagrams illustrate several example SkyView systems and the components needed to
build them. Diagrams do not show a connection to aircraft power and do not imply an
installation location. Additionally, cable lengths and models pictured below should not be
blindly used as a “prescription”. Always consider your aircraft’s particular geometry and module
installation locations before purchasing harnesses, hubs, and splitters.
SV-D1000
USB
Connector
SV-HARNESS-D37
SV-ADAHRS-200
SV-NET-10CP
(with installed D9)
KEY
DB9 Female
Figure 5 – SkyView System with One Display and One ADAHRS
SV-D1000
USB
Connector
SV-BAT-320
SV-HARNESS-D37
SV-EMS-220
SV-NET-6CC SV-ADAHRS-200
SV-ADAHRS-201
SV-NET-SPL
SV-GPS-250
GPS
Wire
Bundle
SV-NET-10CP
(with installed D9)
KEY
DB9 Male
DB9 Female
Figure 6 – SkyView System with One Display, One EMS, One GPS, One Backup Battery, and Two Redundant
ADAHRS