Dynon Avionics SkyView System Installation Guide - Manual (Page 235)

SV-XPNDR-261/262 Installation, Configuration, and Testing
SkyView System Installation Guide – Revision S 11-15
Dimension Cut size
(mm)
Cut size
(inches)
A 17.5 0.69
B 7.2 0.28
C 4.8 0.19

Crimp the center contact to the cable.

Insert the cable into the connector – the center contact should click into place in the
body, the inner shield should be inside the body of the connector and the outer shield
should be outside the body.

Crimp the outer sleeve over the shield.

Slide heat shrink tubing forward (flush to connector) and heat to shrink the tubing.
Transponder-Related SkyView Display Settings
Serial Port Setup
Before the TRANSPONDER SETUP menu can be accessed, the SV-XPNDR-261/262 needs to be
set up as a serial device on each SkyView display on the system. To accomplish this:

Go to SETUP MENU > SYSTEM SETUP > SERIAL PORT SETUP.

Navigate to the serial port that you physically connected the transponder module to in
the previous steps.

Select either “Dynon 261 Transponder” or “Dynon 262 Transponder” as appropriate for
the module you own. Note that other fields are automatically configured and cannot be
changed. Press ACCEPT.

Exit SETUP. Repeat on any other displays on your SkyView system.
The data transmitted between the SkyView display and the SV-XPNDR-261/262 nominally
includes encoded altitude data from SkyView’s ADAHRS. Therefore, no other altitude encoder
hardware or SkyView serial port setup is required. However, some locales may require the use
of a certified altitude encoder with the Dynon SV-XPNDR-261/262 Transponder. SkyView
supports external serial altitude encoders that use Icarus/Garmin format. When one is
connected, the SV-XPNDR-261/262 uses the external altitude encoder data source instead of