Dynon Avionics SkyView System Installation Guide - Manual (Page 306)

SV-COM-X83 Installation, Configuration, and Testing
17-4 SkyView System Installation Guide - Revision S
Figure 107 – SV-COM-PANEL - VERTICAL Panel Cutout and Mounting Hole Dimensions - NOT ACTUAL SIZE
Physical Installation: SV-COM-T8
The figures on the following pages show mechanical dimensions for the SV-COM-T8.
The following installation procedure should be followed to install the SV-COM-T8 remote
transceiver module, remembering to allow adequate space for installation of cables and
connectors.

If you are installing two SV-COM-X83s, it is acceptable to co-locate the two SV-COM-T8
transceiver modules.

Select a position in the aircraft for the SV-COM-T8 that is not too close to any high external
heat source and where reasonable airflow is available. The SV-COM-T8 is not a significant
heat source itself and does not need to be kept away from other devices for this reason.

Avoid sharp bends and placing the cables too near to the aircraft control cables.