Dynon Avionics SkyView System Installation Guide - Manual (Page 86)

SV-D700 / SV-D1000 / SV-D1000T Installation and Configuration
4-24 SkyView System Installation Guide - Revision S
SkyView Audio Output Settings
Go to SETUP MENU > SYSTEM SETUP > AUDIO SETUP to configure audio output settings. Most
of the items in this menu control whether the audio output for a particular alert or alert
category is played or not. The settings that can be adjusted here that are not voice alert toggles
are:

VOLUME CONTROL / TEST – Sets the volume level. While in this menu, sound is played
continuously so that proper audio connectivity and volume levels can be confirmed.
o In this menu only, audio is only outputted from the actual display that is in the setup
menu. This allows one to troubleshoot the physical audio connections. In actual
operation, only one of the displays transmits audio at a time. Which display happens
to be transmitting is automatically managed by SkyView. Since all displays’ audio
outputs are connected together (and to the intercom or audio panel), this is
transparent in actual use.

BOOT SOUND – When set to ON, the system will say “Dynon SkyView” when it first starts
up.

ANGLE OF ATTACK – This sets a pulsing, progressive tone that increases in frequency, similar
in nature to a conventional reed type aircraft stall warning sound to a reed-type stall
warning sound, although it is much more predictable in its progression. It can be set to start
its pulsing tones at either the border of the yellow/green marks on the AOA bars, the
middle of the yellow, or the yellow/red border. The pulsing tones start at the level selected
and get progressively quicker and closer together until a solid tone is played at critical AOA
(in the red.)
o INHIBIT AOA BELOW AIRSPEED – Allows you to set an airspeed below which no AOA
tones are played. This helps prevent nuisance alarms while on the ground and
taxiing, especially in tail draggers.
Contact Inputs
Contact Input #1 – (Optional) External LEVEL Button. See the Autopilot section for detailed
explanation.
Contact Input #2, #3, #4 are currently not supported. A future firmware update may enable this
functionality. Do not connect anything to these pins at this time.
Reserved Connections for Future Use
Do not connect anything to unspecified D37 connector pins (directly or using the display
harness). These are reserved for future use.
Display Setup
You can access important information about a SkyView display as well as configure serial ports,
characterize your display backlight behavior and specify other display-specific settings.