Dynon Avionics SkyView System Installation Guide - Manual (Page 60)

Basic SkyView Display Operation
3-16 SkyView System Installation Guide - Revision S
Figure 15 – Some SkyView Network devices not online, cannot update
If you see a screen similar to the one in Figure 15 above, power on or reconnect all SkyView
Network devices. Typically this error is caused by Autopilot servos or SV-COM-C25 radio not
being powered on.
5. Update the firmware on the unit by pressing UPDATE or press CANCEL to return to the
System Software Menu.
6. To aid in troubleshooting, during the firmware update process, your SkyView system’s
previous configuration files are automatically written to the USB flash drive in a
subdirectory (folder) called “settings_archive”:
TAILNUMBER_SNXXXX_FIRMWAREVERSION_SENSORS_SW_UPGRADE.sfg
TAILNUMBER_SNXXXX_FIRMWAREVERSION_SW_UPGRADE.sfg
How to Export System Settings
This operation creates a set of files on the USB flash drive that contain display
settings, equipment settings, and important calibration information. All of the
filenames contain the tail number and the firmware version.
1. Insert the USB flash drive into one of the display’s USB sockets.
2. Go to the Export Settings Wizard (SETUP MENU > SYSTEM SOFTWARE > EXPORT
SETTINGS…).
3. Create a file name for the settings file.
4. Save the settings file onto the flash drive by pressing EXPORT or press CANCEL to return
to the System Software Menu.