Dynon Avionics SkyView System Installation Guide - Manual (Page 198)

Autopilot Servo Installation, Configuration, and Calibration
10-2 SkyView System Installation Guide - Revision S
If you no longer have this capability, contact Dynon Avionics Technical Support
(contact information at the beginning of this manual). Your servos can be returned
to Dynon Avionics for a firmware update.
Dynon Avionics Autopilot Servo Models
Dynon Avionics offers the following servo models:
Model Number Torque Attachment
SV32
36 inch-pounds
Standard Arm
SV32C Capstan
SV32L Long Arm
SV42
55 inch-pounds
Standard Arm
SV42C Capstan
SV42EL
Extra Long
Arm
SV42L* Long Arm
SV42T *
Torque
Enhancement
SV52
72 inch-pounds
Standard Arm
SV52C Capstan
SV52L* Long Arm
Table 46 – Dynon Avionics Servos
* SV42L, SV42T, and SV52L servos are special order items – contact Dynon Avionics for details.
Compass Calibration Requirement
The SkyView autopilot requires an accurate compass to operate efficiently and comfortably in
heading mode and the radio-based VOR/NAV mode. Therefore it is critical that the ADAHRS be
installed correctly, calibrated, and operating well in all attitudes.