Dynon Avionics SkyView System Installation Guide - Manual (Page 180)

SV-EMS-220/221 Installation and Configuration
7-68 SkyView System Installation Guide - Revision S
Example Voltmeter Setup
Assume this sensor was mapped on the Sensor Input Mapping Wizard as:
PIN # FUNCTION SENSOR NAME
C37 P1 VOLTS VOLTAGE MEASURE MAIN
Now, we want to configure its alert and graphical properties. Go to the Sensor Setup Menu and
open the MAIN VOLTS Page (SETUP MENU > EMS SETUP > SENSOR SETUP > MAIN VOLTS).
Configure MAIN VOLTS with the following properties:

ALARM: OFF

MAXIMUM GRAPHICAL DISPLAY: 15.0 VOLTS

MINIMUM GRAPHICAL DISPLAY: 10.0 VOLTS

SHOW SENSOR UNITS YES

RANGE 1
o ENABLE YES
o COLOR RED
o TOP 11.0 VOLTS
o BOTTOM 10.0 VOLTS

RANGE 2
o ENABLE YES
o COLOR YELLOW
o TOP 12.0 VOLTS
o BOTTOM 11.0 VOLTS

RANGE 3
o ENABLE YES
o COLOR GREEN
o TOP 13.6 VOLTS
o BOTTOM 12.0 VOLTS

RANGE 4
o ENABLE YES
o COLOR YELLOW
o TOP 14.6 VOLTS
o BOTTOM 13.6 VOLTS

RANGE 5
o ENABLE YES
o COLOR RED
o TOP 15.0 VOLTS
o BOTTOM 14.6 VOLTS
Figure 47 – Anatomy of a
Widget: Main Volts