Dynon Avionics SkyView System Installation Guide - Manual (Page 268)

SV-ADSB-470 Installation, Configuration, and Testing
14-8 SkyView System Installation Guide - Revision S
A dual crimp style BNC connector can be completed using a wide range of commercial crimp
tools (for example the Tyco 5-1814800-3). The die apertures for the inner pin and the outer
shield should be approximately 1.72 mm and 5.41 mm respectively.

Strip back the coax cable to the dimensions in the table, as shown in the diagram below.
Slide 25 mm (1 inch) of heat shrink tubing over the cable.

Slide the outer crimp sleeve over the cable – it must go on before securing the center
contact.
Dimension Cut size
(mm)
Cut size
(inches)
A 17.5 0.69
B 7.2 0.28
C 4.8 0.19

Crimp the center contact to the cable.

Insert the cable into the connector – the center contact should click into place in the
body, the inner shield should be inside the body of the connector and the outer shield
should be outside the body.

Crimp the outer sleeve over the shield.
Slide heat shrink tubing forward (flush to connector) and heat to shrink the tubing.
SV-ADSB-470-Related SkyView Display Settings
Before the ADS-B STATUS menu can be accessed, the SV-ADSB-470 needs to be configured on
the SkyView system:
SETUP MENU > SYSTEM SETUP > SERIAL PORT SETUP > SERIAL PORT x SETUP (the serial port you
wired the SV-ADSB-470 to) > SERIAL IN DEVICE > SV-ADSB-470 > ACCEPT (button).
SETUP MENU > TRAFFIC SETUP > SHOW TAIL NUMBERS > YES > ACCEPT (button).
Post Installation Checks
After the SV-ADSB-470 has been configured, confirmation that communication has been
established with the module by performing the following procedure:

Go to SETUP MENU > ADS-B STATUS.