Nortel Networks 1000M - Manual (Page 101)

Wall mounting 101
4 Perform this step only if an expansion cabinet is to be located
immediately next to the main cabinet (or an existing expansion
cabinet). Otherwise, go to the next step (
Step 5 ).
Fasten an alignment bracket (shipped with the cabinet) to the wall as
shown in
Figure 36 "Brackets for horizontal expansion" (page 101) .
The alignment bracket determines the minimum distance between
the main and expansion cabinets if mounted side-by-side. It is not
required if the space between cabinets is significant.
Figure 36
Brackets for horizontal expansion
5 Rest the bottom of the bracket on the line drawn for the expansion
cabinet, and fasten the mounting bracket to the wall with five 25 mm
(1 in.) #12 screws provided (or other suitable fasteners).
Make sure the mounting bracket is even with the line drawn, and
that the hook on the bracket is facing upward as shown in
Figure 36
"Brackets for horizontal expansion" (page 101) .
6 Remove the main cabinet (or expansion cabinet if the main cabinet
has been installed) from its carton and remove its front cover.
If the front cover lock latches are in their locked position, use a
screwdriver and turn the lug on each latch 90¡ to the unlocked
position (refer to
Figure 37 "Unlocking the latches" (page 102) ).
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310 01.04 Standard
Release 5.0 13 May 2008
Copyright © 2008, Nortel Networks
.