Nortel Networks 1000M - Manual (Page 104)

104 Mounting the cabinets
Procedure 7
Mounting the cabinet on the floor
Step Action
1 Remove the main cabinet (or expansion cabinet if the main cabinet
has been installed) from its carton and remove its front cover.
If the front cover lock latches are in their locked position, use a
screwdriver and turn the lug on each latch 90¡ to the unlocked
position. (Refer to
Figure 39 "Unlocking the latches" (page 104) .)
Simultaneously slide both latches in towards the center of the
cabinet.
Grasp the sides of the cover and pull the top outwards, then lift it
upward to remove it from the cabinet.
Figure 39
Unlocking the latches
Note: The bottom of the front cover is supported but not secured
to the cabinet. Be careful not to drop it.
2 Remove the metal drip tray.
Check the wrist strap in the bottom right of the cabinet. It may have
come loose during transit. If so, attach it to the Velcro tab on the
inside right wall of the cabinet.
3 Locate the carton containing the pedestal.
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310 01.04 Standard
Release 5.0 13 May 2008
Copyright © 2008, Nortel Networks
.