Nortel Networks 1000M User Manual
Page 213
213
Installing and connecting
cross-connect terminals
Contents
This section contains the following topics:
"Terminal block requirements" (page 214)
"Terminal block requirements for the Cabinet system" (page 214)
"Terminal block requirements for the Chassis system" (page 214)
"Installing the BIX cross-connect terminal" (page 215)
"Installing the Krone Test Jack Frame for the UK" (page 218)
"Connecting the cables" (page 223)
Introduction
This chapter describes how to install and connect a cross-connect terminal
to a Small System, using either:
•
a BIX cross-connect terminal
•
a Krone Test Jack Frame (UK)
Note: Although the use of the BIX system is not mandatory, it is
the recommended choice.
This chapter contains the following procedures:
•
Procedure 38 "Installing the BIX cross-connect terminal" (page 215)
•
Procedure 39 "Installing the Krone Test Jack Frame (UK)" (page 219)
•
Procedure 40 "Connecting the cables for the Cabinet system" (page
223)
•
Procedure 41 "Connecting the cables for the Chassis system" (page
225)
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310
01.04
Standard
Release 5.0
13 May 2008
Copyright © 2008, Nortel Networks
.