Nortel Networks 1000M - Manual (Page 267)

Configuring Voice Gateway Media Cards on cabinets or chassis 267
<cab#> = 1–4, for the IP Expansion Cabinet or Chassis
3 Configure the ELAN Mask. Enter the following command:
CHG MASK <maskvalue> <cab#>
where
<maskvalue> = xxx.xxx.xxx
<cab#> = 0, for the Main Cabinet or Chassis
4 Configure a new Routing Entry, if the ELAN subnet is connected to
the rest of the IP network. Enter the following command:
NEW ROUTE <destination IP> <gateway IP> <cab#>
<port#>
where
<destination IP> = "0.0.0.0" (the default route)
<gateway IP> = the ELAN network interface default gateway
<cab#> = 0 for Main Cabinet or Chassis
<port#> = 0 for 10BaseT
To configure IP Line for other IP Expansion Cabinets or Chassis,
repeat steps 1–4.
5 Verify your IP address for the Ethernet. Enter the following command:
PRT ELNK
6 Activate New Host entry. Enter the following command:
CHG ELNK ACTIVE <hostname> <cab#>
where
<cab#> = 1–4 for IP Expansion Cabinets or Chassis
7 Update the ELAN network interface configuration. Enter the following
command:
UPDATE DBS
8 Reboot the main cabinet for the changes to take effect or go into
LD 137 and disable and enable the ELNK. Enter the following
commands:
DIS ELNK
ENL ELNK
—End—
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310 01.04 Standard
Release 5.0 13 May 2008
Copyright © 2008, Nortel Networks
.