Nortel Networks 1000M - Manual (Page 81)

Expanding an existing system 81
Figure 26
Daughterboard LEDs
13 Configure the IP daughterboards with IP addresses, cabinet
numbers and MAC addresses for both main and IP expansion
cabinets. Use LD 117 found in Software Input Output Reference
- Maintenance (NN43001-711).
14 Install (if not previously installed) and activate the telephones. Refer
to
"Connecting the telephones" (page 323) .
15 Connect the trunks to the system as described in "Terminal setup"
(page 249) .
16 Perform a system backup, using LD 43.
17 Install any remaining equipment, such as external alarms. Refer to
"Connecting an external alarm" (page 369) and the optional Meridian
Mail feature, if provided.
18 Replace all drip trays and cabinet covers.
—End—
Expanding an existing system
Follow the steps in Procedure 3 "Adding expansion cabinets to an existing
system" (page 81) to add expansion cabinets to an existing system.
Complete each step as described before proceeding with the next step.
References may be made to other chapters in this guide in order to provide
additional information.
Procedure 3
Adding expansion cabinets to an existing system
Step Action
1 Install an expansion daughterboard and cable on the SSC card in
the main cabinet as described in
"Installing fiber expansion" (page
163) or "Installing IP expansion" (page 179) .
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310 01.04 Standard
Release 5.0 13 May 2008
Copyright © 2008, Nortel Networks
.