Nortel Networks 1000M - Manual (Page 188)

188 Installing IP expansion
Note 2: The top connector on the SSC card is for Expansion
Cabinets or Chassis 1 and 3. The lower connector is for
Expansion Cabinets or Chassis 2 and 4.
5 Replace the standoffs on the SSC card with the standoffs supplied
with the IP expansion daughterboard.
6 Record the MAC address found on the back of the daughterboard
of the Expansion Cabinets or Chassis. This will be needed later to
perform the software installation.
7 Connect the faceplate LED to the 3-pin receptacle on the
daughterboard. See
Figure 90 "NTTK02 dual-port 100BaseF
daughterboard" (page 189) for exact location.
8 Mount the daughterboard onto the SSC card by inserting the plastic
post into the designated slot on the daughterboard. See
Figure 86
"SSC card with 100BaseT daughterboard installed" (page 184) for
exact positioning.
Note: Tip the daughterboard down over the post and press
down onto the two standoffs.
9 Firmly press the daughterboard down on the connector pin to secure
in place.
10 Route the expansion cable through the cable router on the SSC card.
11 Insert the SSC card into slot 0 of the Main Cabinet or Chassis. Lock
the card into the faceplate latches.
12 Route the cable through the Cable Routing Guide under the main
cabinet.
Note 1: Be sure to wrap the cable a minimum of one complete
loop around the Cable Routing Guide.
Note 2: The use of the EMC clip is required for 100BaseT and is
optional on 100BaseF connections.
—End—
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310 01.04 Standard
Release 5.0 13 May 2008
Copyright © 2008, Nortel Networks
.