Nortel Networks 1000M - Manual (Page 190)

190 Installing IP expansion
Installing the NTDK20 SSC card on IP expansion cabinets and
chassis
IP Expansion Cabinets or Chassis require an NTDK20 SSC card equipped
with an IP expansion daughterboard. An expansion cabinet requires an
NTDK20HA or newer, or an upgraded NTDK20CA-GA (upgraded using the
NTTK19 SSC Upgrade Kit). An expansion chassis requires an NTDK20HA
or newer, or an upgraded NTDK20EA-GA (upgraded using the NTTK19
SSC Upgrade Kit). For information on upgrading an SSC card, refer to the
chapter on upgrading system controller cards in Communication Server
1000M and Meridian 1 Small System Upgrade (NN43011-459).
This section describes the steps necessary to install the SSC cards,
daughterboards, cables, and any other components that are required on
the SSC card.
Software daughterboard and security device
Refer to Procedure 26 "Installing the software daughterboard and security
device" (page 180) , "Installing the Software Daughterboard and security
device".
Note: While the security device on the SSC card of the IP Expansion
Cabinet or Chassis is installed as described in
Procedure 26 "Installing
the software daughterboard and security device" (page 180) , the device
itself is different. The security device for IP Expansion Cabinets or
Chassis is labelled "NT_REM" and is programmed to match the security
device on the Main Cabinet or Chassis.
IP expansion daughterboards and cables
Either of the following two daughterboards can be installed on the SSC card
in an IP Expansion Cabinet or Chassis:
• NTDK99 single-port 100BaseT IP Expansion daughterboard
• NTTK01 single-port 100BaseF IP Expansion daughterboard
The installation of these daughterboards is the same as described in
Procedure 27 "Installing the 100BaseT daughterboards on the SSC card"
(page 182)
and Procedure 28 "Installing the 100BaseF IP expansion
daughterboard on the SSC card on the Main Cabinet or Chassis" (page
187)
for the SSC card on the Main Cabinet or Chassis, with the following
notable exceptions:
1. The IP expansion daughterboard must be installed in the lower (i.e.,
port 2/4) expansion connector on the SSC card to ensure clock
synchronization.
2. Record the MAC address and associated Expansion Cabinet or Chassis
number, to be used later in the software configuration.
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310 01.04 Standard
Release 5.0 13 May 2008
Copyright © 2008, Nortel Networks
.