Nortel Networks 1000M - Manual (Page 346)

346 Connecting the trunks
Introduction
This chapter describes how to connect trunks directly to the trunk card, with
or without the use of a Power Failure Transfer Unit (PFTU). This chapter
contains the following procedures:
• Procedure 70 "Connecting trunks without PFTU" (page 346)
• Procedure 71 "Connecting trunks with PFTU" (page 347)
• Procedure 72 "Activating a default model trunk" (page 366)
• Procedure 73 "Activating a selected model trunk" (page 367)
Note: The QUA6 PFTU operates with loop start and ground start CO
trunks. However, with ground-start trunks the related telephone set
must have a ground-start button.
During initial software installation on the Small System, you can load a
default database, containing preprogrammed trunk data, into software. If
necessary, you can modify the default data at any time to meet the specific
needs of a customer. For a description of how to modify preprogrammed
trunking data, refer to
"Preprogrammed data" (page 373) in this document.
DANGER
DANGER OF ELECTRIC SHOCK
Always use caution when installing or modifying telephone lines.
Avoid installing telephone wiring during a lightning storm. Do
not install telephone jacks in wet locations unless the jack is
specifically designed for wet locations. Never touch uninsulated
telephone wiring unless the line has been disconnected at the
network interface.
Connecting trunks without PFTU
Procedure 70
Connecting trunks without PFTU
Step Action
1 From the assignment record, determine the location of the trunk
connection and its associated Terminal Number (TN) at the
cross-connect terminal.
2 With cross-connect wire, connect the trunk to the TN.
Make sure that the wiring is not reversed and is on the correct
terminals.
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310 01.04 Standard
Release 5.0 13 May 2008
Copyright © 2008, Nortel Networks
.