Nortel Networks 1000M - Manual (Page 91)

91
Installing the Chassis system
Contents
This section contains information on the following topics:
"Summary of installation procedures" (page 91)
Summary of installation procedures
WARNING
Before a Small System can be installed, a network assessment
must be performed and the network must be VoIP-ready.
If the minimum VoIP network requirements are not met, the system
will not operate properly.
For information on the minimum VoIP network requirements and
converging a data network with VoIP, refer to Converging the Data
Network with VoIP Fundamentals (NN43001-260).
The following list provides a high-level summary of installation procedures
for the CS 1000M Chassis or Meridian 1 PBX 11C Chassis. Where
applicable, the summary contains references to chapters that describe the
procedures in more detail.
Note: For a CS 1000M Chassis system, install the Signaling
Server. Refer to Signaling Server Installation and Commissioning
(NN43001-312) for instructions.
1. Read the safety instructions in "Important safety instructions" (page 59) .
2. Make sure that you have read and completed the instructions contained
in the planning chapters of Communication Server 1000M and Meridian
1 Small System Planning and Engineering (NN43011-220).
3. Make sure that system and site requirements have been met. See
Communication Server 1000M and Meridian 1 Small System Planning
and Engineering (NN43011-220).
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310 01.04 Standard
Release 5.0 13 May 2008
Copyright © 2008, Nortel Networks
.