Nortel Networks 1000M - Manual (Page 110)

110 Mounting the chassis
Procedure 8
Installing the chassis in a 480 mm (19 in.) rack/equipment cabinet
Step Action
1 Fasten the left chassis guide bracket to the left rack/equipment
cabinet support. Insert two #12-24 self-tapping screws into the two
middle slots in the chassis guide bracket and into the respective
holes in the left rack/equipment cabinet support. Fasten the screws.
Note: The rack/equipment cabinet brackets help guide the
chassis into place, and allow one person to install the chassis
in the rack/equipment cabinet.
2 Fasten the right chassis guide bracket to the right rack/equipment
cabinet support. Insert two #12-24 self-tapping screws into the two
middle slots in the bracket and into the respective holes in the right
rack/equipment cabinet support. Fasten the screws. See
Figure 43
"Chassis guide bracket installed in a rack" (page 110) .
Figure 43
Chassis guide bracket installed in a rack
3 Attach the left ear bracket (marked with an "L") to the holes on the
left side of the chassis (near the front).
Use two #8-32 machine screws. Position the ear bracket so that the
four holes on the bracket flange are nearer to the back of the chassis.
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310 01.04 Standard
Release 5.0 13 May 2008
Copyright © 2008, Nortel Networks
.