Nortel Networks 1000M - Manual (Page 226)

226 Installing and connecting cross-connect terminals
Figure 107
Cable connectors on the back of the chassis
3 Tighten the Velcro straps when you have connected each cable to
the chassis.
4 Terminate all the 25-pair cables installed at the cross-connect
terminal.
Label all the cables at the cross-connect terminal blocks according
to the card slot assignment plan.
5 Install the AUX cable in the lower 9-pin connector located on the
bottom left-hand side of the chassis. See
Figure 108 "AUX cable
connector" (page 227) .
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310 01.04 Standard
Release 5.0 13 May 2008
Copyright © 2008, Nortel Networks
.