Nortel Networks 1000M - Manual (Page 340)

340 Connecting the telephones
2 Press the pound key (#) to select the default model.
3 Press the pound key again to select the default extension number.
You hear a short, high-pitched beep lasting four seconds followed by
silence (relocation tone).
Note: If the extension number is already in use by another
telephone, you hear three beeps followed by continuous dial
tone (special dial tone).
To accept the default extension number press the pound key.
To select a new extension number, manually enter an extension
number and press the pound key.
If the extension number is not available for use, you hear a fast,
high-pitched broken tone (overflow tone). This happens when you
choose an extension number manually or when extension numbers
are entered for additional keys. A default extension number is not
offered if it is not available. You must repeat
step 3 and you must
manually enter a new extension number.
Note: If other keys require secondary extension numbers,
you are prompted until you enter all of the required extension
numbers for the model. These extension numbers cannot be
defaulted. You are prompted for each additional extension
number with three beeps followed by continuous dial tone
(special dial tone). When you are programming an extension
number, the lamp associated with that number on the telephone
is lit.
—End—
Activating a customized model with a character display
Procedure 68
Activating a customized telephone
Step Action
1 Plug the telephone set into the jack and wait 20 seconds before
picking up the handset. If you do not receive dial tone, replace the
handset and wait another 10 seconds before going off-hook again.
Repeat this procedure until dial tone is received.
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310 01.04 Standard
Release 5.0 13 May 2008
Copyright © 2008, Nortel Networks
.