Nortel Networks 1000M - Manual (Page 294)

294 Installing software
ATTENTION
IMPORTANT
BOOTP is a broadcast message used for IP Address discovery.
• For Point-to-Point installation, you must select option 1.
• For Layer 2 LAN installation, the recommended selection is
option 1.
• For Layer 3 LAN installation, you must select option 2.
IP Configuration Menu:
1. Automatically Using BOOTP
2. Using Manual Configuration
3. Keep Existing Configuration
[q]uit, [p]revious, [m]ain menu, [h]elp or [?], <CR>
- redisplay
Enter Selection: 2
8 Configure IP expansion parameters.
The following sample IP parameters are examples. Use the correct
parameters for your system.
Enter Media Gateway/Expansion New IP Parameters:
Media Gateway/Expansion IP: 47.147.20.101
Call Server/Main IP: 47.147.10.100
Media Gateway/Expansion NetMask: 255.255.255.0
L3 Configuration...
Media Gateway/Expansion Router: 47.147.20.1
Media Gateway/Expansion New IP Parameters:
Media Gateway/Expansion IP: 47.147.20.101
Call Server/Main IP: 47.147.10.100
Media Gateway/Expansion NetMask: 255.255.255.0
Media Gateway/Expansion Router: 47.147.20.1
Is this correct? (y/n/[a]bort):
y <CR> (yes)
n <CR> (no)
a <CR> (abort, return to main menu)
Note 1: Media Gateway/Expansion Router appears only in a
Layer 3 configuration.
Note 2: The IP address is configured on the Main
Cabinet/Chassis using LD 117.
If the response was NO, repeat step 8 .
If the response was YES, continue with the next step ( step 7 ).
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310 01.04 Standard
Release 5.0 13 May 2008
Copyright © 2008, Nortel Networks
.