Nortel Networks 1000M - Manual (Page 268)

268 Voice Gateway Media Card configuration
Configuring IP Line data
IP Line data can be configured in OTM or Element Manager.
Configuring IP Line data with OTM 2.2
Refer to IP Line Fundamentals (NN43001-500) and IP Phone Fundamentals
(NN43001-368) for a detailed description of the procedures listed below.
1. Manually add an IP Telephony node. Do not use this node anywhere
else. It is unique for this cabinet or chassis.
2. Configure the card properties of the Voice Gateway Media Card.
3. Configure DSP Profile data.
4. Configure SNMP traps and ELAN gateway routing table.
5. Configure the Main Cabinet or Chassis ELAN network interface IP
address, survivable IP Expansion Cabinet or Chassis ELAN network
interface IP address, and TLAN voice port.
Enter the ELAN network interface address of the Main Cabinet or
Chassis.
Define the survivable IP Expansion Cabinet or Chassis IP address
in OTM. There is an extra field in OTM to configure the survivable IP
Expansion Cabinet or Chassis IP address and TLAN network interface.
Use the same secondary IP address as the IP Expansion Cabinet or
Chassis ELAN network interface address. If the IP Expansion Cabinet
or Chassis is non-survivable, leave the default value at "0.0.0.0".
Note: The ELAN network interface address of the survivable IP
Expansion Cabinet or Chassis entered must be on the same subnet
as the Main Cabinet or Chassis.
6. Configure security for SNMP access.
7. Configure file server access.
8. Configure QOS.
9. Configure SNTP.
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310 01.04 Standard
Release 5.0 13 May 2008
Copyright © 2008, Nortel Networks
.