Figure 123 connector j7 – Nortel Networks 1000M User Manual
Page 255
Installing and connecting an Ethernet cable
255
Note: A jumper block located on connector J7 (near the Fiber 2
connector) (see
Figure 122 "J7 Jumper Plug location on NTDK20
and
Figure 123 "Connector J7" (page
) on the component side of the NTDK20 SSC card must be
in place for the Ethernet connection to function. The NTDK20
SSC card is normally shipped with the plug installed. If the
Ethernet connection does not appear to function properly, check
the jumper plug to make sure that it is installed.
Figure 123
Connector J7
3
If not previously done, configure the Ethernet port in LD 117, as
described in Software Input Output Reference - Maintenance
(NN43001-711).
—End—
Chassis system Ethernet connection
The Chassis system provides a 10 Mbit Ethernet connection to a Local
Area Network (LAN). The Ethernet cable connector is at the back of the
chassis on the bottom left-hand side. See
Figure 124 "Ethernet connection"
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310
01.04
Standard
Release 5.0
13 May 2008
Copyright © 2008, Nortel Networks
.