Nortel Networks 1000M - Manual (Page 425)

Removing numbering plan conflicts 425
Changing or removing the preprogrammed night number
If you wish to change or remove the night number, use LD 15. (For some
countries, the default value of the night number is listed in
Table 76 "Default
numbering plan: important extension numbers" (page 377) .)
LD 15
REQ CHG where CHG = Change
TYPE CDB where CDB = Customer Data Block
CUST x where "x" = Customer number
NIT1
or bbbb where"bbbb" = the new extension number (DN)
X aaaa where "aaaa" = the current night number (the
night number now removed)
Conflicts with Flexible Feature Codes
If the preprogrammed Flexible Feature Codes interfere with the programming
required for the Small System, use LD 57 to remove the data from the
system. (For some countries, default FFCs are listed in
Table 90 "Flexible
Feature Codes" (page 385) .)
LD 57
To change one or more access codes, enter the following commands:
REQ CHG END Change or end
TYPE FFC FFC = Flexible feature codes
CUST 0-31 Customer Number
FFCT YES (NO) FFFC Confirmation tone
CODE aaaa Enter access code prompt (aaaa)
AAAA xx Enter the new access code prompt (AAAA)
CODE <CR> Return to REQ
REQ END End program
To remove one access code, enter the following commands:
REQ OUT Action request
TYPE FFC FFC = Flexible feature codes
CUST 0-31 Customer Number
FFCT YES (NO) FFC Confirmation tone
ALL NO Remove specific access code
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310 01.04 Standard
Release 5.0 13 May 2008
Copyright © 2008, Nortel Networks
.