Nortel Networks 1000M - Manual (Page 293)

Installing software in a new system 293
Procedure 54
Installing software for IP expansion, using a PC Card
Step Action
1 Make sure the SSC card is in slot 0 of the Expansion Cabinet or
Chassis.
2 Power up the system and observe the terminal screen. The following
message displays:
INSERT SOFTWARE DELIVERY CARD
3 Insert the PC Card in slot A located in the faceplate of the SSC card.
Carefully press on the PC Card until it is firmly seated. See
Figure
130 "PC Card slot location" (page 281) .
4 The Software Installation Main Menu displays.
Select option 1 to install software on the IP Expansion Cabinet or
Chassis.
Software Installation Main Menu:
1. Media Gateway/IPExpansion Cabinet
2. Call Server/Main Cabinet
[q]uit, [h]elp or [?], <CR> - redisplay
Enter selection: 1
5 In the Media Gateway/Expansion Cabinet Software Installation
Main Menu, select option 1 to install software from the Software
Delivery card (PC Card).
Media Gateway/Expansion Cabinet Software Installation
Main Menu:
1. Media Gateway/Expansion Cabinet Installation - From
Software Delivery Card
2. Utilities
[q]uit, [p]revious, [m]ain menu, [h]elp or [?], <CR>
- redisplay
Enter selection: 1
6 Confirm that you wish to perform IP configuration.
Do you wish to do IP configuration? (y/n/[a]bort): y
7 The IP Configuration menu displays.
Select Manual Configuration (option 2).
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310 01.04 Standard
Release 5.0 13 May 2008
Copyright © 2008, Nortel Networks
.