Nortel Networks 1000M - Manual (Page 368)

368 Connecting the trunks
The prompt
"ROUTE ACCESS?"
appears.
5 Enter the access code of the configured trunk route to which you
want to add the trunk and press the pound key (#).
The prompt
"TN?"
asks you to enter a TN from one of the installed trunk cards. If you
do not enter a valid route number, "TN?" does not appear and the
screen remains the same. If the card does not match the route, the
prompt "ROUTE ACCESS?" appears again, and you hear overflow
tone.
6 Enter the TN in Small System format (cu).
The response
"MODEL?"
prompts you to select a model number for the trunk.
7 Enter a trunk model number for the specified TN and route, and
press the pound key.
The character display shows:
"OK"
After a delay of approximately 4 seconds you hear special dial tone
and the sequence is repeated when the following prompt appears
on the character display.
"TN?"
8 Hang up or repeat the sequence.
The sequence ends when the last unit in the card is used and the
program is complete, or when you hang up the telephone receiver.
Note: The model used for the first trunk activated in the
sequence will be the default for all subsequent trunks until the
telephone is hung up unless you manually enter a new trunk
model number.
—End—
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310 01.04 Standard
Release 5.0 13 May 2008
Copyright © 2008, Nortel Networks
.