Nortel Networks 1000M User Manual
Page 159
159
Installing Small System Controller
cards on stand-alone systems
Contents
This section contains information on the following topics:
"Installing the NTDK20 SSC card on the cabinet or chassis" (page 160)
Introduction
This chapter describes how to prepare and install the Small System
Controller (SSC) card on a Small System that consists of a single cabinet,
single chassis, or single chassis with chassis expander.
ATTENTION
IMPORTANT!
If you are installing a system with fiber or IP expansion, do not follow the
procedure in this chapter. Refer to
"Installing fiber expansion" (page 163)
or
"Installing IP expansion" (page 179)
You must install an SSC card, equipped with a software daughterboard,
in slot 0 of the cabinet or chassis.
The cabinet or chassis requires the SSC card vintage NTDK20HA or newer,
or upgraded NTDK20CA-GA (upgraded using the NTTK19 SSC Upgrade
Kit). For information on upgrading an SSC card, refer to the chapter on
upgrading system controller cards in Communication Server 1000M and
Meridian 1 Small System Upgrade (NN43011-459).
"Installing optional circuit cards" (page 193)
describes additional circuit
cards, which are optional to the Small System.
Note: In a CS 1000M Cabinet or Chassis system, the NTDK20 SSC
card is also referred to as the Call Server.
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310
01.04
Standard
Release 5.0
13 May 2008
Copyright © 2008, Nortel Networks
.