Nortel Networks 1000M - Manual (Page 105)

Floor mounting 105
Remove the pedestal from the carton and locate the four leveling
feet.
Install the feet into the base of the pedestal.
4 Install the cabinet on the pedestal.
Lean the cabinet backwards. From under the cabinet and with a
pair of pliers, break off the two tabs located in the openings on the
bottom of the cabinet where the door hinges join the cabinet, as
shown in
Figure 40 "Installing the pedestal" (page 105) .
Figure 40
Installing the pedestal
Place the cabinet on the pedestal and make sure that it is properly
seated. Align with the guide at the rear of the cabinet and pedestal.
(Refer to
Figure 41 "Mounting the cabinet on the pedestal" (page
106) .)
Install the four #14 screws that are shipped with the pedestal, two at
the bottom rear and two where the tabs were removed, and secure
the cabinet to the pedestal.
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310 01.04 Standard
Release 5.0 13 May 2008
Copyright © 2008, Nortel Networks
.