Nortel Networks 1000M - Manual (Page 270)

270 Voice Gateway Media Card configuration
5. Configure the Main Cabinet or Chassis ELAN network interface IP
address, survivable IP Expansion Cabinet or Chassis ELAN network
interface IP address, TLAN voice port, and routes.
Enter the ELAN network interface address of the Main Cabinet or
Chassis.
Define the survivable IP Expansion Cabinet or Chassis IP address
in Element Manager. There is an extra field in Element Manager to
configure the survivable IP Expansion Cabinet or Chassis IP address
and TLAN voice port. Use the same secondary IP address as the IP
Expansion Cabinet or Chassis ELAN network interface address. If the
IP Expansion Cabinet or Chassis is non-survivable, leave the default
value at "0.0.0.0".
Note: The ELAN network interface address of the survivable IP
Expansion Cabinet or Chassis entered must be on the same subnet
as the Main Cabinet or Chassis.
6. Configure file server access.
7. Configure loss and level plan.
8. Configure the card properties of the Voice Gateway Media Card.
9. Submit and transfer the node information.
Figure 128
Element Manager LAN configuration
Transferring node configuration from Element Manager to the Voice
Gateway Media Cards
The IP Telephony node and card properties are configured using
Element Manager. The configuration data is saved to the Call Server and
then transferred to the Voice Gateway Media Cards. Refer to IP Line
Fundamentals (NN43001-500). Complete the following steps:
1. Set the Leader IP address.
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310 01.04 Standard
Release 5.0 13 May 2008
Copyright © 2008, Nortel Networks
.