Nortel Networks 1000M - Manual (Page 341)

Activating telephones 341
If successful, the character display shows either "MODEL? X" (if the
telephone relocation feature is not in use) or "RELOC OR MODEL?
X" (if the telephone relocation feature is in use). "X" represents the
default model for the telephone that you are activating.
Note 1: If you do not see the prompt "MODEL X" after lifting the
handset, disconnect the telephone from the wall jack, wait five
seconds, and reinsert the telephone into the jack. The telephone
now shows "MODEL X" when you lift the handset.
Note 2: The 20 second time interval is required for the system to
determine whether the set is new or if it is being relocated using
the Modular Telephone Relocation feature.
2 Press the digits associated with the customized model and press
the pound key (#).
Dial tone disappears after the first digit is pressed and you hear
special dial tone after you press the pound key. If you enter a valid
model number the character display reads "OK, EXTENSION?". If
you enter an invalid model, the previous prompt is reissued and
you hear overflow tone.
3 Enter the customized extension number and press the pound key.
You hear relocation tone. The character display shows "OK".
OR
If the extension number is already in use by another telephone,
you hear special dial tone again. The character display shows
"MULTI-LINE, EXTENSION?".
OR
If the extension number is not available for use, you hear overflow
tone. The character display shows "ERROR, EXTENSION?" and
you must repeat this step.
Note: If other keys require secondary extension numbers,
you are prompted until you enter all of the required extension
numbers for the model. These extension numbers cannot be
defaulted. The text display prompting for further extension
numbers is "KEY kk EXT?" where "kk" represents the key
number requiring the extension number. Each prompt for another
extension number is accompanied by special dial tone. When
you are programming an extension number, the lamp associated
with that number on the telephone is lit.
4 Hang up the telephone handset.
After approximately 10 seconds, the telephone is configured.
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310 01.04 Standard
Release 5.0 13 May 2008
Copyright © 2008, Nortel Networks
.