Nortel Networks 1000M - Manual (Page 290)

290 Installing software
If the response was YES, the software will be installed on the system.
Continue with the next step (
step 25 ).
25 Observe the TTY or terminal screen. Progress messages will appear
on the screen as the software is installed. When the installation
program has ended, the following message displays:
Installation completed successfully.
Continue to observe the terminal screen. The system is operational
when the following message displays:
INIXXX
26 Perform an EDD using LD 43. Refer to Software Input Output
Reference - Maintenance (NN43001-711) for further information
on LD 43.
27 For an IP expansion Small System, configure the IP Daughterboard
MAC and IP addresses. Refer to LD 117 in Software Input Output
Reference - Maintenance (NN43001-711).
—End—
Installing software on IP Expansion Cabinets or Chassis
Point-to-Point or Layer 2 with BOOTP configuration
For Point-to-Point or Layer 2 with BOOTP configuration, you do not need
a TTY connected to the IP Expansion Cabinet or Chassis. Power up the
system, and the software installs automatically.
Layer 2 or Layer 3 with manual configuration
With a TTY connected to the IP Expansion Cabinet or Chassis:
• Follow Procedure 53 "Installing software for IP expansion, using the
preprogrammed software daughterboard" (page 290) to install software
from the SSC card, using the preprogrammed software daughterboard.
• Follow Procedure 54 "Installing software for IP expansion, using a PC
Card" (page 293) to install software using a PC Card.
Procedure 53
Installing software for IP expansion, using the preprogrammed software
daughterboard
Step Action
1 Power up the system. The Software Installation Main Menu
displays.
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310 01.04 Standard
Release 5.0 13 May 2008
Copyright © 2008, Nortel Networks
.