Nortel Networks 1000M - Manual (Page 342)

342 Connecting the telephones
Note: If you replace the handset before you complete the
prompt sequence, the installation automatically fails. This can be
useful if you make an error and want to restart the procedure.
—End—
Activating a customized model without a character display
Procedure 69
Activating a customized telephone
Step Action
1 Plug the telephone set into the jack and wait 20 seconds before
picking up the handset. If you do not receive dial tone, replace the
handset and wait another 10 seconds before going off-hook again.
Repeat this procedure until dial tone is received.
Note: The 20 second time interval is required for the system to
determine whether the set is new or if it is being relocated using
the Modular Telephone Relocation feature.
2 Press the digits associated with the customized model and press
the pound key (#).
Dial tone disappears after the first digit is pressed, and you hear
three beeps followed by continuous dial tone (special dial tone) after
you press the pound key.
3 Enter the customized extension number and press the pound key.
You hear a short high-pitched beep lasting four seconds, followed by
silence (relocation tone).
If the extension number is already in use by another telephone, you
hear special dial tone again.
If the extension number is not available for use, you hear a fast,
high-pitched broken tone (overflow tone), and you must repeat this
step.
4 Hang up the telephone handset.
After approximately 10 seconds, the telephone is configured.
Note: If other keys require secondary extension numbers,
you are prompted until you enter all of the required extension
numbers for the model. These extension numbers cannot be
defaulted. You are prompted for each additional extension
number with three beeps followed by continuous dial tone
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310 01.04 Standard
Release 5.0 13 May 2008
Copyright © 2008, Nortel Networks
.