Nortel Networks 1000M User Manual
Page 259
259
Starting the Chassis system
Contents
This section contains information on the following topics:
"Startup procedures" (page 259)
Introduction
This chapter describes how to start the Chassis system and how to make
sure that the system is operating correctly.
This chapter contains the following procedures:
•
•
Procedure 49 "Startup procedure for a previously installed system"
(page 261)
Before you continue with the procedures described in this section, make
sure all necessary hardware is connected to or installed in the system.
Check all connections, and make sure that you have installed all of the
circuit cards correctly.
Startup procedures
Before you start the system, complete
through
in
.
Procedure 48
Startup procedure for a new system installation, using the Small System
Controller card
Step
Action
1
Test the power outlet. Make sure that the correct voltage of power is
present before you plug the power cord into the outlet. The source
must match the label on the back of the chassis.
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310
01.04
Standard
Release 5.0
13 May 2008
Copyright © 2008, Nortel Networks
.