Nortel Networks 1000M - Manual (Page 367)

Activating a selected model trunk 367
"OK".
After a delay of approximately 4 seconds you hear special dial tone.
The sequence is repeated when the prompt
"TN?"
appears on the character display.
The next valid trunk TN is automatically incremented after each
trunk is activated.
8 Terminate the sequence by hanging up the telephone receiver.
OR
Repeat the sequence by going through the steps again.
By entering "#" when the procedure repeats, you accept the next TN
and are prompted for the model type.
By entering "#" again, you accept the previously accepted model.
Note: The model chosen during the first trunk activation
sequence will be the default model for all subsequent trunks
until you hang up the telephone or manually enter a new trunk
model number.
—End—
Activating a selected model trunk
Due to the automatic 30 second timeout on the administration menu,
prepare the data that you want to input before you begin. To determine
the corresponding TNs and trunks, check the location of trunk cards in
the cabinet or chassis or use LD 32.
Procedure 73
Activating a selected model trunk
Step Action
1 Pick up the handset of the administration telephone.
2 Enter the administration Flexible Feature Code to access the
administration menu.
3 Enter the default administration telephone password.
You hear special dial tone and the prompt "TASK?" appears on the
top line of the character display. The second line of the character
display reads "1 ADD TRUNK".
4 Select "1 ADD TRUNK" by entering the number "1".
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310 01.04 Standard
Release 5.0 13 May 2008
Copyright © 2008, Nortel Networks
.