Nortel Networks 1000M - Manual (Page 237)

237
Installing and connecting SDI and
Ethernet network interfaces
Contents
This section contains information on the following topics:
"Introduction" (page 237)
"Modem setup requirements" (page 238)
"SDI ports" (page 238)
"Cable connections and adapters" (page 239)
"Installing and connecting SDI ports" (page 241)
"NTDK20 SSC card" (page 241)
"NTDK23, NTDK25, and NTDK80 Fiber Receiver cards" (page 244)
"NTAK02 SDI/DCH card" (page 246)
"Terminal setup" (page 249)
"Installing and connecting an Ethernet cable" (page 252)
"Cabinet system: IP expansion 10BaseT port" (page 253)
"J7 Jumper plug" (page 253)
"Chassis system Ethernet connection" (page 255)
Introduction
This chapter contains modem setup requirements and the following
procedures for connecting communication devices to the Small Systems:
• Procedure 43 "Connecting SDI ports on the SSC card" (page 242)
• Procedure 44 "Connecting SDI ports to the Fiber Receiver card" (page
245)
• Procedure 45 "Setting up the terminal" (page 249)
• Procedure 46 "Connecting the Ethernet cable to the Cabinet system"
(page 254)
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310 01.04 Standard
Release 5.0 13 May 2008
Copyright © 2008, Nortel Networks
.