Nortel Networks 1000M - Manual (Page 199)

Circuit cards 199
You can install this line card in:
• slots 1 through 10 in the main cabinet or slots 11 through 50 in the
expansion cabinets
• slots 1 through 3 in the chassis, slots 7 through 10 in the chassis
expander, or in the expansion chassis
Procedure 30
Installing the Universal Trunk card
Step Action
1 Set the jumpers for the NT8D14 Universal Trunk circuit card
according to
Table 26 "NT8D14 Universal Trunk: modes and option
settings" (page 199) .
Table 26
NT8D14 Universal Trunk: modes and option settings
Modes Location
Jumper
strap
Central (CO) J1, J2 OFF
2-way TIE trunk (loop Dial Repeat) J1, J2 OFF
2-way TIE trunk (Outgoing
Incoming Dial) J1, J2 OFF
Recorded Announcement (RAN) J1, J2 OFF
Paging trunk J1, J2 OFF
Japan CO/DID operation J1, J2 OFF
DID operation
Loop length>2000 ohms J1, J2 ON
DID operation
Loop length <2000 ohms J1, J2 OFF
OFF indicates no strap present. J1 and J2 locations apply to all 8 trunks.
2 Insert the card in its assigned slot.
—End—
NT8D15 E and M Trunk card
The E and M trunk card provides four trunks which can function as 2W
E&M, 4W E&M, and Paging.
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310 01.04 Standard
Release 5.0 13 May 2008
Copyright © 2008, Nortel Networks
.