Nortel Networks 1000M - Manual (Page 442)

442 Central Answering Position
Procedure 80
Installing a key expansion module
Step Action
1 Remove the telephone handset and place the telephone upside
down on top of a level, solid work surface covered with soft material
or paper to avoid damaging the keys or the telephone face.
2 Disconnect all cords from the telephone.
3 Remove the two screws from the stand assembly and unsnap it from
the telephone by pressing inward at the back of the stand (where it
meets the base) and pulling upward.
Note: If you are using an M2616 telephone and it is equipped
with a Programmable Data Adapter, the Programmable Data
Adapter must be removed and installed into the key expansion
module footstand.
4 If the telephone is not yet equipped with the power board, install the
power board now.
5 Align the bottom of the key expansion module(s) to the bottom of the
telephone. (Refer to
Figure 143 "Key expansion module connections
(bottom view)" (page 444) .)
6 Snap the end of the ribbon cable connector(s) into the bottom
interface jack on the key expansion module. Snap the other end
of the ribbon cable into the interface jack in the left side of the
telephone. Gather the excess cable in the base of the key expansion
module.
7 If you are adding a second key expansion module, snap the end of
a second ribbon cable connector into the bottom interface jack on
the second key expansion module. Snap the other end of the ribbon
cable into the top interface jack on the first key expansion module.
(Refer to
Figure 143 "Key expansion module connections (bottom
view)" (page 444) .) Gather the excess cable in the base of the
second key expansion module.
8 If the telephone is equipped with a Programmable Data Adapter,
reconnect the data cable to the base telephone jack. Make sure that
the Programmable Data Adapter cable and the interface cable do
not get pinched between the base and the stand.
9 Secure the footstand to the key expansion module(s) and to the
telephone by placing the footstand tabs into the slots provided
on the base of the key expansion module and telephone and
pressing down. Make sure that the stand is firmly attached to the
Nortel Communication Server 1000
Communication Server 1000M and Meridian 1 Small System Installation and Commissioning
NN43011-310 01.04 Standard
Release 5.0 13 May 2008
Copyright © 2008, Nortel Networks
.