Hach-Lange TITRALAB 840_845 Reference Manual - Manual (Page 161)

Titra Lab ® TitraLab 840 and 845 Reference Manual
Page 161
Routine mode In “ROUTINE” mode the user is able to select and run methods.
Clear-text messages and icons present on the large graphic display
guide the user at every step. However, the routine user cannot create
or modify methods, reagents or electrodes.
When the working order is respected i.e. ELECTRODE then
TITRANT, you will be able to perform the following:
• RUN the active method,
• CALIBRATE an electrode (if required),
• INSTALL the reagent system and CALIBRATE a reagent (if
required).
Refer to "User’s rights", page 194 .
Run window This window displays information about measurements when an
analysis is in progress. The displayed information depends on the type
of method which is running.
How to run an analysis?
Refer to "Running a method (preliminary steps)", page 162 .
Refer to "Running a sequence with a sample changer", page 166 .
Figure 29: Run window of an End point method
Name of the sample.
Name of the method and time elapsed since
measurements started or remaining time until
end of the End point delay.
Running test number and temperature
measured (if a probe is used) or entered.
Volume of titrant dispensed and measurement
value (pH or mV).
Titrant delivery speed is displayed live.
Real time curve (pH or mV = f(dispensed
volume )).