Hach-Lange TITRALAB 840_845 Reference Manual - Manual (Page 194)

Titra Lab ® TitraLab 840 and 845 Reference Manual
Page 194
User ID (Yes/No) If specified, User ID will be asked for each time an analysis is run.
Enter in:
Setup menu > Configuration menu
User list List of user defined methods, electrodes and reagents. The list is
initialised to the preprogrammed methods, electrodes and reagents
User’s rights The Supervisor and Routine modes set the user’s rights as shown in
the table below:
Figure 34: User’s rights
Supervisor Routine
Create, edit sequence.
Remove all methods from a sequence.
Delete a sequence Yes Yes (if the
Supervisor
gives the
right to),
see
"Demand:
Unlocked",
page 70
.
Create method, electrode, reagent Yes No
Copy method, electrode, reagent Yes No
Edit method, electrode, reagent Yes No
Delete method, electrode, reagent Yes No
Reset method, electrode, reagent
parameters Yes No
Reset parameters to factory settings Yes No
Select method, electrode, reagent Yes Yes
Check method parameters Yes Yes
Install/replace/remove reagents Yes Yes
Run sequence, method, electrode and
reagent calibrations Yes Yes
Consult results Yes Yes