Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 10)

ix
IM 04L31A01-17E
Setup Procedure Using Operation Keys
Below is the basic flow of operations when changing the settings of the CX2000 using
the front panel keys.
Settings related to communications are configured in the basic setting mode. The
procedure used to enter the basic setting mode is described in the procedures for each
item. Basic setting mode cannot be entered while control operation, data acquisition, or
computation using the computation function (/M1 option) is in progress.
1. Press the [#7] (Option) soft key. The communication function setup menu
appears.
2. Press the [#1] (Ethernet, Serial) soft key. The communication (Ethernet, Serial)
setting display appears.
3. Press the arrow keys to move the cursor to the setup item.
The parameter box containing
the cursor is blue.
4. For setup items that display possible choices at the bottom of the display, press
the soft key below the choice. For setup items that require characters to be
entered in an entry box (numeric value input pop-up window), press the [Input]
soft key, enter the appropriate characters in the entry box, and press the DISP/
ENTER key.
Parameter selections
(Selection example for [DNS On/Off].
Press either the [On] or [Off] soft key.) Parameter entry box
(Example of the entry box
for the IP address)
• The setup item boxes that have not been changed remain white.
• The setup item boxes that have been changed turn yellow.
The setup item boxes that
have been changed turn yellow.
The setup item boxes that have
not been changed remain white.
5. Set other setup items according to steps 3 and 4.
Names and Uses of Parts and Setup Procedures Using the Operation Keys