Yokogawa Data Acquisition with PID Control CX2000 User Manual
Page 35
2-5
IM 04L31A01-17E
Ethernet Interface
2
Procedure
For the basic flow of operation, see “Setup Procedure Using Operation Keys” on page
ix. For the procedure of entering characters and numbers, see the user’s manual IM
04L31A01-01E
or 04L31A01-03E.
1.
Press the MENU key.
The setting mode (control) display appears.
2.
Press the FUNC key for approximately 3 s.
The basic setting menu appears.
3.
Press the [#7] (Communication) soft key ([#9] (Communication) soft key on the
CX1000).
The communication function setting menu appears.
4.
Press the [#1] (Ethernet, Serial) soft key ([#1] (Ethernet (IP_Address)) soft key
on the CX1000).
The Communication (Ethernet, Serial) setting display appears.
CX2000 Communication (Ethernet, Serial) setting display
CX1000 Communication (Ethernet
(IP_Address)) setting display
On models without the serial communication function,
[Serial] and [Memory out] parameters do not appear.
Setting the IP Address
5.
Use the arrow keys to move the cursor to the [IP-address] box.
6.
Press the [Input] soft key. An entry box (numeric value input pop-up window)
appears.
7.
Enter the IP address to be assigned to the CX.
8.
Press the DISP/ENTER key. On the CX1000, select [ENT] and then press the
DISP/ENTER key.
The IP address that you entered appears in the [IP-address] box.
Setting the Subnet Mask
Set the subnet mask according to the system or network to which the CX belongs. If
the subnet mask is not required, proceed to “Setting the Default Gateway.”
9.
Use the arrow keys to move the cursor to the [Subnet mask] box.
10.
Press the [Input] soft key. The [Subnet mask] entry box opens.
2.3 Configuring of the Ethernet Interface