Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 242)

9-9
IM 04L31A01-17E
9
Green Series Communications
• Control output type
• If the connecting model is UT series, select from the following:
Control Output Type Soft Key Menu
Time proportional PID relay contact output Relay
Time proportional PID voltage pulse output Voltage-pulse
Current output Current-output
On/Off-control relay contact output On/Off-control
• If the connecting model is “ETC,” you cannot select the control output type.
• Alarm type
• If the connecting model is UT series, select from the following. However, the
selectable items vary depending on the connecting model. See the UT Series
user’s manual.
Alarm Type Soft Key Menu*
Off Off
PV high-limit alarm (energize) PV-H-E
PV low-limit alarm (energize) PV-L-E
Deviation high-limit alarm (energize) Dev-H-E
Deviation low-limit alarm (energize) Dev-L-E
Deviation high-limit alarm (deenergize) Dev-H-D
Deviation low-limit alarm (deenergize) Dev-L-D
Deviation high & low limit alarm (energize) Dev-HL-E
Deviation within high & low limits alarm (energize) D-W-HL-E
PV high-limit alarm (deenergize) PV-H-D
PV low-limit alarm (deenergize) PV-L-D
PV high-limit alarm (energize/hold) PV-H-ES
PV low-limit alarm (energize/hold) PV-L-ES
Deviation high-limit alarm (energize/hold) Dev-H-ES
Deviation low-limit alarm (energize/hold) Dev-L-ES
Deviation high-limit alarm (deenergize/hold) Dev-H-DS
Deviation low-limit alarm (deenergize/hold) Dev-L-DS
Deviation high & low limit alarm (energize/hold) Dev-HL-ES
Deviation within high & low limits alarm (energize/hold) D-W-HL-ES
PV high-limit alarm (deenergize/hold) PV-H-DS
PV low-limit alarm (deenergize/hold) PV-L-DS
Timer, upward detection, hours & minutes TimeUp1
Timer, downward detection, hours & minutes TimeDown1
Timer, upward detection, minutes & seconds TimeUp2
Timer, downward detection, minutes & seconds TimeDown2
Sensor grounding alarm Sensor
Self diagnosis output Prog-Diag
FAIL output FAIL
SP high-limit SP-H
SP low-limit SP-L
Output high-limit Out-H
Output low-limit Out-L
Heater burnout alarm 1 Burnout1
Heater burnout alarm 2 Burnout2
* Some of the dislayed characters are abbreviated even further on the CX1000.
• If the connecting model is UT320, UT321, UT350, UT351, or UT420, you
cannot set alarm number 4.
• If the connecting model is UT420, UT450, UT520, UT550, or UT750, you can
set the timer function alarm type only for alarm number 1.
• The heater burnout alarms can be used if the connecting model is UT320,
UT321, UT350, or UT351.
• If the connecting model is “ETC,” you cannot select the alarm type.
9.4 External Loop Setting > Basic Setting